Before operating any Simpson Strong-Tie® powder-actuated tool you must read and understand the Operator's manual and be trained by an authorized instructor in the operation of the tool. You must then pass a test (online or written) and receive a certified operator card to become a Certified Operator.

If you prefer a written test: the test and an Operator's manual are also included with each tool kit. Extra copies can be obtained by contacting your local Simpson Strong-Tie representative, or the Sydney office at 02 98317700.

To avoid serious injury or death:

• ALWAYS make sure that the operator and bystanders wear safety glasses. Hearing and head protection are also recommended.
• ALWAYS post warning signs when powder-actuated tools are in use. Signs should state "Powder-Actuated Tool in Use" and should be posted within the area where the tool is being used.
• ALWAYS store powder-actuated tools unloaded. Tools and powder loads should be stored in a locked container out of the reach of children.
• NEVER place any part of your body over the front muzzle of the tool even if no fastener is present. The fastener, pin or tool piston can cause serious injury or death in the event of an accidental discharge.
• NEVER transport fasteners or other hard objects in the same pocket or container with powder loads. These objects may strike the powder loads, thereby setting them off and causing serious injury or death.
• NEVER attempt to bypass or circumvent any of the safety features on a powder-actuated tool.

Safety equipment such as safety glasses and ear plugs are recommended when using powder-actuated tools.

PAT Material Safety Data Sheet (PDF)

To avoid serious injury or death:

• ALWAYS hold the tool perpendicular (90°) to the fastening surface to prevent ricocheting fasteners. Use the spall guard whenever possible.
• NEVER attempt to fasten to soft, thin, brittle or very hard materials such as drywall, light gauge steel, glass, tile or cast iron as these materials are inappropriate. Conduct a pre-punch test to determine base material adequacy.
• NEVER attempt to fasten to soft material like wood or drywall (fastening through soft materials into an appropriate base material may be allowed if the application is appropriate).
• NEVER attempt to fasten to a spalled, cracked or uneven surface.

PAT Warning Sign (PDF)

• PT-27 Operator's manual (PDF)
• PTP-27AL Operator's manual (PDF)
• PTP-27ALMAGR Operator's manual (PDF)